Skip to content

Start and verify KX Sensors

This page explains how to start KX Sensors after installation with kxsctl, check that all processes started, and find the KX Developer ports.

You operate KX Sensors with the kxsctl command line interface. For more information, see About kxsctl.

Start KX Sensors

SSH to one of the target hosts and run the following commands. In a multi-node environment, run them from one host only.

kxsctl enable <list of nodes>   # For example: kxsctl enable a b c
kxsctl start system

For more start and stop options, see Start and stop the system.

Verify startup

  1. From any target host, check that all expected processes started:

    kxsctl status system
    
  2. Check that no errors were logged during startup:

    grep -i error $KXS_LOG_DIR/*
    

    The k-errs utility, which greps for all ERROR and FATAL entries in the logs, does the same job. See Utility aliases.

KX Developer ports

If you use KX Developer, make sure the KX Developer ports are open between the KX Sensors hosts and the hosts from which you access KX Developer. To find the ports, run the following command on one of the KX Sensors hosts:

kxsctl status ide

Next steps